ACX100

[Gustavo Chain]

Gustavo Chain wrote:

> Hola, tengo un laptop thoshiba satellite A15 con una tarjeta DLINK 
> DWL-G650+ PCMCIA.
>
> Esta utiliza un chip TI, y el módulo apropiado es ACX100 (ACX111 para 
> las 11g). El tema es que no he logrado conectarme a ninguna red, he 
> tratado varias formas pero no logro dar.
> Independiente del chip y/o módulo q utilicen, cuales son los pasos a 
> seguir para:
>
> 1º Buscar algun AP.
> 2º CONECTARSE!!!
>
> De antemano, muchas gracias
>
> Adjunto algunos detalles:
>
> */# lspci -v/
> [...]
> 0000:02:00.0 Network controller: Texas Instruments ACX 111 54Mbps 
> Wireless Interface
>        Subsystem: D-Link System Inc DWL-G650+ AirPlusG+ CardBus 
> Wireless LAN
>        Flags: bus master, medium devsel, latency 64, IRQ 11
>        Memory at 1f820000 (32-bit, non-prefetchable)
>        Memory at 1f800000 (32-bit, non-prefetchable) [size=128K]
>        Capabilities: [40] Power Management version 2
>
>
> /# iwconfig/
>
> lo        no wireless extensions.
>
> eth0      no wireless extensions.
>
> sit0      no wireless extensions.
>
> wlan0     IEEE 802.11b+/g+  ESSID:"STA58FCB9"  Nickname:"acx100 
> v0.2.0pre8"
>          Mode:Auto  Channel:1  Access Point: 00:00:00:00:00:00   
>          Bit Rate=54 Mb/s   Tx-Power=15 dBm   Sensitivity=1/3  
>          Retry min limit:7   RTS thr:off            Encryption key:off
>          Power Management:off
>          Link Quality:0  Signal level:0  Noise level:0
>          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
>          Tx excessive retries:0  Invalid misc:0   Missed beacon:0
>
> /# wifiscanner /
> WifiScanner v0.9.6 (c) 2002-2004 Herv�Schauer Consultants 
> (Jerome.Poggi en hsc-labs.com)
>
> Interface used: wlan0
> Debug Level: 0
> Output filename: <none>
> PCap dump file: <none>
> Dot output filename: <none>
> Channel scan : 0 (All channels)
> Sleep between channel hop: 200
> Max packets before quit: 0 (Don't quit)
> Date format: Timestamp
> Curses Screen size detection: Enabled
> IDS active: Disabled
> Send IDS alert to Syslog: Disabled
> ioctl error : "Operation not supported"(95) - req=0xBFC4AE50 Warning : 
> Change state of interface to enable failed
> *
>
>
he probado modo manage, ad-hoc auto, essid asigando o any, he jugado con 
el power, txpower y nada
probé iwlist waln0 scan(ning) nada quieres funcionar.

Incluso instalé un windose y funciona impeque.

Voy a probar instalando frontend q hagan la pega por mi :)